Chimney safety week
This is a national campaignDates:
Monday, September 08, 12:00 AM - Saturday, August 16, 12:00 AM
Cheshire Fire and Rescue Service are supporting chimney safety week (8th to 14th September 2014).
During 2013/14 firefighters tackled 105 chimney fires in Cheshire.
Most chimney fires are preventable. Regular inspection and cleaning of chimney flues will help prevent fires within chimneys.
Here are some top tips for safer chimneys:
Keep chimneys and flues clean and well maintained
Make sure embers are properly put out before you go to bed
Always use a fire guard to protect against flying sparks from hot embers
Clean your chimney regularly
The latest statistics show that there are approximately 7,000 chimney fires a year in England, but most of these are preventable.
To keep yourself and your family safe from fire you should take care to have your chimney swept regularly, depending upon what fuel you burn, before the colder winter months set in and you begin to use your fire and chimneys again.
If the worst should happen, a smoke alarm can give you the extra time you need to escape in a house fire - make sure you test yours regularly.
How often should you clean your chimney?
Regular maintenance of your chimney will depend on the fuel you burn:
Oil - Once a year
Gas - Once a year
Bituminous - coal Twice a year
Wood - Up to four times a year
Smokeless coals - At least once a year
Most common causes of chimney fires
The most common causes of chimney fires are:
Improper appliance sizing
Burning unseasoned wet wood
Infrequent sweeping and cleaning
Overnight burning or smouldering wood for long periods in wood stoves
Tips to reduce the risk of chimney fire
It is recommended that these measures are taken to help reduce the risk of chimney fire:
Chimneys must be swept on a regular basis this can be as much as three times in the burning season (winter) but at least once per season regardless of fuel type.
All wood burned must have a moisture content of no more than 17 percent.
It is important to purchase the correct size appliance for your room, an appliance which is too large will never be used hot enough to volatize all of the fuel within the wood and unburned fuel will pass up the chimney as smoke and condense within the flue as extremely flammable creosote.
To minimize creosote production in a wood stove these steps can be followed:
Once the fuel load has been ignited and the flue has been heated to its operating temperature, the stoves air supply should be adjusted to limit the amount of air to avoid over firing and excessive heat loss up the chimney. They should, however, be open enough to maintain moderate flaming combustion in the fire box. (The flames should fill the entire window or fire box without being sucked up the chimney).
To determine if this is maintained the condition of the fire should be checked through any glass panels and the density of the smoke as it exits the flue at the top should also be checked.
An internal probe type thermometer located within the flue can be used to ascertain if flue temperatures are of a sufficient temperature or if they are excessive, magnetic flue temperature thermometers can also be utilised to this end.
It is important when using a multi fuel stove that you control the burning of the appliance by the air inlets provided for this purpose not using any dampers which could obstruct the safe passage of exhaust from being able to exit the appliance.
Remember a blocked flue can kill and the exclusion of air will put out a fire.
Chimney fire safety leaflet (new window, PDF 95KB)
Carbon Monoxide poisoning (CO)
All chimneys and flue-ways should be cleaned and checked during the summer months to ensure they are free from debris and in full working order before the heating season. A blocked or defective chimney can cause both chimney fires and carbon monoxide poisonings so it's very important to employ a professional qualified Chimney Sweep such as those certified by NACS.
Find out more about carbon monoxide poisoning
Registered Chimney Sweeps
To find a certified Chimney Sweep, or for more information on chimney fire safety, please visit one of the following websites:
The National Association of Chimney Sweeps
The National Association of Chimney Sweeps (NACS) is the national trade body for professional Chimney Sweeps in the UK and is also a full member of ESCHFOE representing Great Britain. The NACS is dedicated to consumer chimney safety. The NACS has a dedicated Chimney Training Centre (CTC) for professional Chimney Sweeps to undertake training. The centre is also CITB accredited for the NVQ Chimney Engineering.
The National Association of Chimney Sweeps (opens in new window)
Guild of Master Sweep
The Guild is a professional organisation working closely with European colleagues, to raise standards in the industry and promote customer awareness around the dangers associated with burning carbon based fuels. The Guild is a member of the European Federation of Chimney Sweeps (ESCHFOE).
Guild of Master Sweep (opens in new window)
The Association of Professional and Independent Chimney Sweeps
Formed in April 2002, APICS recognises the independence of sweeps but forms them into a Trade Association. APICS is keen to raise the standard of sweeps throughout the country and keep all members updated with the latest technology and health and safety issues. They assess all new sweeps to ensure competency and encourage all members to educate the public with regard to chimney fires and CO poisoning.
The Association of Professional and Independent Chimney Sweeps (opens in new window)